Na_reboot - Stops and then restarts the node. Reboot [ -t minutes ] reboot [ -s ] reboot [ -r ] reboot [ -d dump_string ] reboot [ -f ] reboot halts the node and then restarts it. Reboot is commonly used to allow modified configuration files to take effect or to run a newly installed version of Data ONTAP. NFS clients can maintain use of a file over a halt or reboot, although the node will fail to respond during that time. CIFS, FCP, and iSCSI clients cannot safely maintain use of a file over a halt or reboot. If the node is running CIFS, FCP or iSCSI, you may use the -t option to specify the time before shutdown. If reboot is invoked without -t, it displays the number of CIFS users, the number of open CIFS files, the number of mapped LUNs and the number of connected FCP and iSCSI clients. ![]() Review the Site Requirements Guide on the NetApp Support Site and gather all IP addresses and other network. 4 Adding a second controller to create an HA pair. ![]() Netapp Fas3140 ManualThen it prompts you for the number of minutes to delay. Cifs terminate automatically notifies all CIFS clients that a CIFS shut-down is scheduled in mins minutes, and asks them to close their open files. Netapp Fas3140 ManualService manual troy-bilt. CIFS files that are still open at the time the node reboots will lose writes that had been cached but not written. FCP and iSCSI will not notify clients, but will allow administrators to confirm that the mapped LUNs are not in use. LUNs that are in use at the time the node reboots will result in client failures. Reboot logs a message in the /etc/messages file (see messages(5)) file to indicate that the node was rebooted on purpose. -t minutes Reboots after the indicated number of minutes. Applies only if the node is running CIFS, FCP, or iSCSI. -s Initiates a clean system shutdown, followed by a power cycle reboot. (When the -s flag is omitted, reboot performs a clean shutdown but does not power cycle the appliance.). The reboot -s command is equivalent to physically turning the power to the head off and back on after typing 'halt'. Netapp Fas3140 Power SupplyThe reboot -s command does not power cycle the appliance shelves. -r Bypasses the shutdown process and initiates a power cycle reboot, without first performing a clean system shutdown. (When the -r flag is omitted, reboot performs a clean shutdown but does not power cycle the appliance.). The reboot -r command is equivalent to physically turning the power to the head off and back on, without first halting the system. Use this command only when instructed to do so by technical support. The reboot -r command does not power cycle the appliance shelves.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |